C Declaración De Incorporación - Trox Technik X-CUBE Instrucciones De Servicio

C Declaración de incorporación
according to the EU Machinery Directive 2006/42/EG, Annex II, 1.B
Manufacturer:
TROX GmbH
Heinrich-Trox-Platz
D-47504 Neukirchen-Vluyn
Description and identification of the partly completed machinery:
Product:
Type:
We herewith declare, that the above mentioned products (partly completed machinery) are in compilance with
the following essential requirements of Machinery Directive 2006/42/EG:
1.3.3.; 1.3.4.; 1.3.7.
The safety objectives of Low Voltage Directive 2006/95/EC have been met in accordance with Appendix I,
Section 1.5.1., of the EC Machinery Directive.
Further we declare, that the relevant technical documention is compiled in accordance with part B of Annex
VII.
The relevant information of the partly completed machinery will be transmitted by mail, in response to a
reasonable request by the national authorities. The intellectual property rights of the manufacturer remain
unchanged.
Reference to the harmonised standards used, as referred to in Article 7(2):
EN 349:1993+A1
EN 1037:1995+A1
EN 60204-1:2006/A1
EN 547-2:1996+A1
EN 547-3:1996+A1
EN 1005-3:2002+A1
EN ISO 13857:2008
EN ISO 12100:2010-11
Important note:
The partly completed machinery must not be put into service until the final machinery into which it is to be
incorporated has been declared in confomity with the provisions of the Machinery Directive 2006/42/EG.
Neukirchen-Vluyn, 06.08.2013
Jan Heymann
Authorised Representativ, CE-marked products
Declaration of incorporation
for partly completed machinery
Air Handling Unit
X-CUBE, Supply and Extracted Air Unit
Safety of machinery - Minimum gaps to avoid crushing of parts of the human body
Safety of machinery - Prevention of unexpected start-up (Amendment)
Safety of machinery - Electrical equipment of machines - Part 1: General requirements (IEC
60204-1:2005)
Safety of machinery - Human body measurements - Part 2: Principles for determining the dimensions
required for access openings
Safety of machinery - Human body measurements - Part 3: Anthropometric data
Safety of machinery - Human physical performance - Part 3: Recommended force limits for machinery
operation
Safety of machinery - Safety distances to prevent danger zones being reached by upper and lower limbs
(ISO/DIS 13857:2006)
Safety of machinery - General principles for design - Risk assessment and risk reduction (ISO
12100:2010)
Unidad de tratamiento de aire X-CUBE
Declaración de incorporación
The art of handling air
Person residing within the Community authorised
to compile the relevant technical documentation:
Jan Heymann, TROX GmbH
Page 1 / 1
107