Installation Steps
Press (4) hood inserts into the (4) square holes. If
necessary use tape to hold them firmly in place.
weatherstrip
3
Using a phillips screwdriver install (4) screws with (4) washers through the hood shield and into the hood inserts.
5
Reposition the rubber weatherstrip back in place OVER
the hood shield flanges.
6
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2009 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo, Chromeflector
TM
TM
Set the hood shield in place, aligning hood shield holes with the
previously installed hood inserts.
4
hood insert
hood shield
weatherstrip
Close hood. Install bump ons at pre-cleaned locations
7
7
, and the AVS
logo are trademarks of Lund International, Inc.
TM
TM
Page 2 of 2
square hole
hood
washer
screw
DO NOT OVER TIGHTEN
on the painted hood/fender surface.