Installation Steps - AVS Ventvisor 774040 Manual Del Usuario

Installation Steps

Clean the door's painted surface where the
1
Attach the top and rear flanges to the door's painted
surface. Remove tape liner by pulling on free ends.
3
4 Piece Set
5
NOTE: Actual application may vary slightly from illustrations.
visor will attach.
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle's painted surface.
Remove the tape liner from the rear flange. Peel back
2" of tape liner from each end of top flange.
rear
flange
2
Apply pressure to top and rear tape flanges to secure.
4
OR
Page 2 of 3
top flange
free end