Installation Steps - AVS Ventvisor Instrucciones De Instalación

Installation Steps

Clean the door's painted surface & the front-
mirror cap where the visor will attach.
1
Slide deflector forward so foam seal compresses against
mirror edge. Attach the top and rear flanges to the door's
painted surface. Remove tape liner by pulling on free
3
4 Piece Set
5
NOTE: Actual application may vary slightly from illustrations.
ends.
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle's painted surface.
Remove the tape liner from the rear flanges. Peel back
2" of tape liner from each end of top flange.
rear
flange
2
Apply pressure to top and rear tape flanges to secure.
4
OR
Page 2 of 3
top flange
free end
black
foam