Installation Steps - AVS Bugflector II Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Align center holes in hood shield with hood inserts
Press (3) hood inserts into the (3) square holes. If
installed in Step 3. Note the location of the two
necessary use tape to hold them firmly in place.
OUTBOARD holes in hood shield and mark with a
grease pencil. Remove hood shield.
3 4
Center a piece of protective film over each grease pencil mark, and wrap film around the hood edge.
X2
5
Install (2) brackets on OUTBOARD hood shield flanges using machine screws and black washers.
screw
washer
hood shield
bracket
6
Position hood shield back in place on hood. Ensure that the holes
Using a phillips screwdriver install (3) screws with
in hood shield are properly aligned with the holes in the hood and
(3) washers at the hood shield's center holes.
that the brackets align with the protective film.
X3
square hole
hood
hood insert
hood shield
washer
screw
7 8
DO NOT OVER TIGHTEN
Page 2 of 3