Installation Steps - AVS Stepshield Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from drawings.
Open passenger side front door & clean Peel back 2" (5cm) of tape liner from
Stepshield mounting location. each end of passenger side (RF)
Stepshield.
1
2
Align the Stepshield with the previously
cleaned door sill. Gently press the exposed
areas of the tae against the door sill and
verify position.
3
With the stepshield in its final position, remove re- Apply pressure to taped areas to secure.
maining tape liner by pulling on free ends.
4
5
Repeat Steps 1-5 for opposite side Stepshield.
The rear Stepshields unstall utilizing the same procedure. It is necessary to remove the round plug from the sill
before installing Stepshield.
Remove plug and discard.
6
Page 2 of 3