Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Align visor to the previously cleaned surface. The lateral flange will apply above the black or chrome trim on the door. The front end
flange will attach on top of the mirror base plate and the rear end flange will apply on the black trim.
front end
flange
plastic mirror
cap
3
Gently press the exposed areas of tape against the surface and
verify position.
4
Apply pressure along all flanges to ensure proper adhesion of tape.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
visor in
position
black or chrome
trim
With the visor in its final position, remove the remaining tape liner
5
4 Piece Set
The lateral flange will attach above the chrome or black trim onto the
7
Repeat Steps 1-7 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
window
frame
cross section of visor in place
by pulling on free ends.
The rear visor attaches with the same
preparation methods as the front visor.
painted surface.
rubber window
channel