Double Din Radio Provision - Metra 99-5823CH Instrucciones De Instalación

Double DIN radio provision

1. Cut and remove the center
bar from the radio housing.
(Figure A)
2. Snap the Double DIN
brackets to the inside edge
of the radio housing.
(Figure B)
3. Slide the radio into the
radio housing assembly
and secure the radio to the
assembly using screws
supplied with the radio.
(Figure C)
4. Snap the double DIN trim
plate into the radio housing.
Kit Assembly
(Figure A)
(Figure B)
®
99-5823CH
5. Connect the climate extension
harness to the climate control
harness removed in step 2
of disassembly, and then into
the 99-5823CH radio/climate
panel.
6. Locate the factory wiring
harness in the dash. Metra
recommends using the proper
mating adapters from Metra
and AXXESS to integrate your
new radio. Re-connect the
negative battery terminal
and test the radio for proper
operation.
7. Reassemble the dash in
reverse order of disassembly
using the 99-5823CH radio/
climate panel instead of the
factory radio trim panel.
5
(Figure C)