1: Replacing The Library; Removing The Existing Library - StorageTek L80 Manual Del Usuario

Replacing the Library
This chapter describes how to replace the library.
Note: The CRU does not include the drive tray assemblies, personality module,
■

Removing the Existing Library

WARNING:
Possible personal injury: Use a mechanical device to lift and position the
library. The library weighs 63.5 to 122.5 kg (140 to 270 lb).Use at least two
people and a mechanical device to lift and position the library. Make sure
you read the information in
beginning.
ADVERTENCIA
Posibilidad de lesiones físicas: Utilice un dispositivo mecánico para
levantar la biblioteca y colocarla en su posición. La biblioteca pesa entre
63,5 y 122,5 kg (140 a 270 lb). Para levantar la biblioteca y colocarla en su
posición se requieren como mínimo dos personas. Antes de poner
manos a la obra, asegúrese de leer la información presentada en
"Técnicas de levantamiento de objetos" en la página xxi
Observe these precautions before beginning:
• Read the safety instructions in
• Stop all data processing on the channel to which the library is connected before
disconnecting the library.
• Make sure there is no activity on the SCSI bus before disconnecting the external
SCSI cables. Stop all processes on the client server.
• Make sure all signals are terminated at each end of the SCSI bus. Do not mix single-
ended and differential terminators.
• If the drives are daisy-chained, stop all data processing on the channel to which the
drives are connected before disconnecting the drives.
96051
external cables, or cartridges. Do not return them with the library.
Sixth Edition
"Lifting Techniques" on page xiii
"Safety."
1
before
1-1