Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the Existing Library
34. Remove the four screws and screw nut clips securing the library to the rack.
35. Reattach the two decorative covers.
36. Reattach the door.
Note: Install the top pin first, to make it easier to balance the door while holding it.
37. Close and lock the door.
WARNING:
Possible personal injury: Use a mechanical device to lift and position the library. The
library weighs 63.5 to 122.5 kg (140 to 270 lb).Use at least two people and a
mechanical device to lift and position the library.
ADVERTENCIA
Posibilidad de lesiones físicas: Utilice un dispositivo mecánico para levantar la
biblioteca y colocarla en su posición. La biblioteca pesa entre 63,5 y 122,5 kg (140 a
270 lb). Para levantar la biblioteca y colocarla en su posición se requieren como
mínimo dos personas.
38. Remove the library from the rack and place it on a sturdy surface.
39. See
Figure 1-1 on page 1-11
bottom, with callout 15, and continue moving up. See
the library.
1-10
1. Screw (4)
and its callout list to continue packing the library. Start from the
Sixth Edition
Chapter 2
for instructions about returning
96051
Publicidad
Tabla de contenido
