Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the Existing Library
WARNING:
Lifting hazard: Depending upon the drive type, each drive and tray weighs between
5.0 kg (11 lb) and 5.8 kg (12.7 lb). Follow the lifting instructions in
Techniques" on page
ADVERTENCIA:
Riesgo al levantar: En función del tipo de unidad, cada unidad y bandeja pesa entre
5,0 kg (11 lb) y 5,8 kg (12,7 lb). Para levantarlas, siga las instrucciones de
de levantamiento de objetos" en la página
12. Pull out the drive tray and set it aside.
CAUTION:
Load/unload problems: The latch must be fully loosened (disengaged) before you
slide the tray into the slot. If the latch arm contacts part of the library frame as it is
being tightened, it cannot be rotated to its fully locked position, and the tray will not
be firmly locked into the drive slot. This can cause alignment problems and the
camera can have problems reading the target.
13. Holding the replacement drive tray as shown in the figure below, turn the drive tray latch knob all
the way to your right so that it is in its fully unlocked position.
14. Slide the replacement drive tray into the empty slot.
1-4
xiii.
1. Knob
2. Range
3. Latch arm (shown disengaged)
Sixth Edition
xxi.
"Lifting
"Técnicas
96051
Publicidad
Tabla de contenido
