Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the Existing Library
1. End all jobs the robot and the drives are performing.
2. Remove power from the library by placing the input line switches at the bottom of the frame to the
O position.
3. Disconnect the AC power cords.
4. Insert the door key into each of the two locks on the door, and unlock and open the door.
5. Look into the drive area to determine where the drives are installed.
6. Use the following steps to remove all the drive trays, but do not remove the drives from the trays.
CAUTION:
Possible component damage: Do not use a screwdriver for the drive door latch or
drive tray latch knob.
7. At the rear of the library, turn the drive door latch knob to your left, and open the door.
1-2
1. Input line switch (2)
2. AC power cord receptacle (2)
1. Latch
1
L201_239
Sixth Edition
96051
Publicidad
Tabla de contenido
