Turn On And Test The Installation - Mowox RM 30 Li Instrucciones De Funcionamiento Originales

2. Plug charger directly into an electrical outlet. Do not abuse the cord. Never carry
anything by or pull on the power cord.
3. Do not operate a damaged charger. Replace damaged cords or charger immediately at
an authorized service centre
4. Do not charge in wet locations. Do not charge at temperatures is above 40° C or below
5° C.
5. Keep the mower and charger away
from water, heat emitters or
chemicals. Be careful not to damage
the charger cord - by keeping it
away from sharp edges.
6. Connect the charger to the charging
station. Align the notch on the
power cord connector with the
groove on the adaptor connector.
LED
off
constant
green light
on
flashing
green
red
5 . 5 T
5 . 5 T
U R N O
U R N O
Once the LED light is constant green, you have a working area for your robot. Now please
first check that the boundary wire pegs are fully hammered down.
Cut boundary wire and its consequential damage not subject to
Rev 19
LED indicator
description
no power
ready for mowing (battery
fully charged, boundary
wire OK)
boundary cut off or
connected wrongly
battery on charging
N A N D T E S T T H
N A N D T E S T T H
Once these connections are made,
plug in t he power supply. There
is a LED indicator on the charging
station – after proper installation, it
should flash in constant green. If
the LED is off, check the power
connections firstly; I f the LED is on
but not constant green, refer to
the trouble shooting guide below.
solution
Check power supply.
Correct connection.
Change the two wire ends and check if
the boundary wire has a break
somewhere.
Await full charge or set "Start" – "OK".
E I N S T A L L A T I O
E I N S T A L L A T I O
20 (EN)
N
N