Mowox RM 30 Li Instrucciones De Funcionamiento Originales página 80

The robotic
mower
stopped in tall
and rough
grass.
The robotic
mower turns
in circles and
then stops.
During set
working time,
the robotic
mower goes
back to the
station, or the
battery
cannot be
charged on
the charging
station.
The robotic
mower cannot
start or stops
and turns off.
The robotic
mower goes
back to the
station and
stays there,
although it's
the scheduled
working time.
Rev 19
Error LED The robotic mower
blue flashing stopped because of
too high current in the
motor.
Error LED The robotic mower is
red flashing outside the working
area.
The boundary wire is
wrongly connected or
cut-off.
There is no power
supply.
Error LED 1. If the battery
blue steadily temperature is above
75° C, the robotic
mower will go back to
or stay on the charging
station.
2. If the battery temp.
is higher than 45° C or
lower than 0° C, it will
stop charging and wait
on the base.
Error LED The battery has
blue steadily reached its natural end
of lifetime.
Error LED If the PCB (main board)
blue steadily in the robotic mower is
over 90° C, the mower
will stop cutting, go
back to the station and
wait to cool down.
1. Check if too tall grass in the lawn
blocks the. If so, please cut the grass
to less than 60 mm using a
conventional mower.
2. Increase the cutting height.
3. Check if the blade disk is jammed. If
needed, clean.
4. Check if the wheels are jammed.
5. Restart the robotic mower or take it
back to the charging station.
1. Make sure the robotic mower is in
the working area.
2. Check if the LED indicator on the
charging station is constant green.
3. If the Robotic mower runs outside
of the boundary at one spot several
times, please check if there is a high-
voltage cable nearby or underneath.
Change the position of the boundary
wire.
4. If the robotic mower runs outside
of the boundary on a slope, avoid that
area by changing the position of the
boundary wire.
5. Restart the robotic mower or take it
to the charging station.
1. On summer season, please set the
working time to the early morning;
don't let the robotic mower work
during hot daytime.
2. After having cooled down to the
rated range (charge: 0-45° C;
discharge: 0-90° C), the robotic
mower will automatically restore to
the set program.
During wintertime, take the robot to a
warm area – whether that is your
house or a winter service offered from
our customer service.
The number of charging cycles is
limited. Your dealer will offer
replacement batteries.
1. On summer season, please set the
working time to the early morning;
don't let the robotic mower work in
the hot daytime.
2. After the PCB has cooled down, the
robotic mower automatically restores.
37 (EN)