Mowox RM 30 Li Instrucciones De Funcionamiento Originales página 82

The robotic
mower is
very noisy.
The robotic
mower stays
on the
station or the
mower keeps
going back to
the station.
The robot
operates
during rain.
If in doubt, bring your robot in for service.
Strictly follow the instructions of this manual. Faulty maintenance
or installation are not covered by the warranty
Rev 19
none 1. Damaged cutting
blades.
2. Cutting blade
flooded by residues
(tapes, ropes, plastic
fragments, etc).
3. Damaged cutting
motor or driving motor.
4. Other damages on
the parts of the mower.
none Wrong working time
setting.
none The sensor measures
the resistance of the
surface, which can
change due to dirt.
1. Replace blades; the 3 blades need to
be changed at the same time.
The robotic mower's cutting
efficiency depends on sharp blades,
so please keep them in good
condition.
2. Stop the robot. Use gloves to avoid
any risk of injuries and remove any
residues from the blades.
3. Get the motor repaired or replaced
by the service station.
Check the working time setting.
Outside of the set working time
window, the robotic mower will hover
to the station and stay there.
Clean the rain sensor with a cloth
soaked in a detergent solution.
39 (EN)