Mowox RM 30 Li Instrucciones De Funcionamiento Originales página 81

Robot doesn't
move.
The battery
cannot be
charged.
The robotic
mower does
not boot.
Screen is off.
The robotic
mower cannot
enter the
charging
station.
The robotic
mower circles
around along
the boundary
wire.
The robotic
mower
stopped while
running back
to the station.
The robotic
mower
behaves
abnormally
around islands
(flower beds,
pool, etc.).
Rev 19
Error LED The robot is controlled
blue flashing by a microcomputer.
Possible serious
damage to it.
Error LED Wrong contact of the
blue steadily charging pins.
The battery has
reached its natural end
of life.
Error LED There are metal parts
red steadily between the magnets
and the deck.
none No power supply.
none If the charging station
is not installed
correctly, the robotic
mower cannot enter it.
None High power cable close
to or underneath the
boundary wire affects
the boundary signal.
none Objects on the
boundary wire blocked
the mower's
movement.
none boundary wire
incorrectly placed
around the islands
Try to reboot the robot; a continuing
error indicates a serious damage to
the mother board.
Please check it if the power source is
with problem, or clean the charging
pins if needed.
Replace the battery.
Take off the metal parts if needed.
Take appliance to a service dealer.
1. Make sure the main power switch is
"ON".
2. When you first use the robotic
mower the battery may not be fully
charged. Put the robotic mower into
its charging station.
3. Hit the power key on control panel,
then input PIN and start the robotic
mower.
4. If the screen is still off, please carry
the robotic mower to the charge
station. Make sure the main switch is
"ON"
5. Contact the service station.
1. Make sure the LED indicator on the
charging station is constant green.
2. Check if the boundary wire under
and in front of the charger are
aligned.
3. Check if the charging station is
positioned correctly.
4. Level off the charging station.
Check if there is a high-power cable
close to the boundary wire or
underneath it; change the position of
the boundary wire.
Remove any obstacle on the
boundary.
Relocate the boundary wire.
38 (EN)
for the battery to be charged.