Panel Description - HQ-Power PROMIX20M Manual Del Usuario

• Select a location where the device will not be exposed to water or moisture, excessive heat or dust. Do not leave
any cables lying around.
• Do not use the device under extreme temperatures (> 30°C, < 5°C).
• Keep the device away from heaters.
• Familiarise yourself with the operation of the device before bringing it into service and do not allow operation by
unqualified individuals. Damage is usually caused by unprofessional operation of the device.
• Do not use spray cleaners to clean the faders and do not clean the device with abrasives or solvents. Use a clean
and damp cloth instead.
• Use the original packaging if the device is to be transported.
• Do not attempt to make adjustments or execute repairs. Consult a qualified technician instead.
• Removing the bar code will void the warranty.
• Use only high-quality cables in order to obtain the highest sound quality.
• You should only use the device for the applications described in this manual. Damage caused by unauthorised
use will automatically void the warranty and may lead to electroshocks, burns or short circuits.
• Connecting devices: put the power switch in the OFF position. Make sure the devices in question are also OFF.
Place the master control in the minimum position.
Remember to consult a qualified technician if necessary.
4. Installation and Operation
Connect all the stereo input sources first and then connect the microphones and the headphones. Make sure all faders
are placed in their minimum positions ("0"). Connect the stereo outputs to the power amplifier and/or tape decks.
Plug the device into an AC power source.
Note: Use shielded low-capacitance stereo cables for the RCA connections. The quality of the cables is essential for
high-quality sound reproduction.

5. Panel Description

a) Top Panel (fig. 1)
1. Input selector: each input channel has 2 stereo input options. This
switch enables you to select which of the inputs plugged into the mixer
you wish to use. Both channels have a PHONO and a LINE input.
2. Gain control: each input channel has a gain control to compensate for
fluctuating input levels.
3. Tone control: 2-band equalizer for channel 1 and 2 consisting of bass
and treble controls.
4. Master level: This controls the overall level of the master output.
5. Headphone level: This controls the volume in your headphones.
6. Channel fader: a high-quality 45mm fader to control the output level of
each channel.
7. LED output indicator: a nine segment LED ladder with power-on
indicators and a range of -21 to +6dB.
8. Removable crossfader: a super fast crossfader between the 2 input
channels. The signal only changes when the crossfader has left the
midway point.
9. Cue-selector: With this button you select which channel you want to
hear in the headphone.
PROMIX20M
2 VELLEMAN