HQ-Power PROMIX20M Manual Del Usuario página 3

b) Rear Panel (fig. 2)
1. Power switch: this switches the AC power to the mixer on or off.
2. AC input socket: the mixer is supplied with an external AC power
adapter of 12 VAC/500mA.
3. Unbalanced master output: the stereo outputs are low-impedance,
unbalanced RCA connections. The output level is controlled by the
master fader.
4. Record outputs: used to send the signal to an external device e.g. a
recorder. These outputs are not affected by the master level control.
5. Line/CD input: these inputs are unbalanced RCA jacks. Use them to
connect a CD player or any other device (but NOT a turntable).
6. Phono inputs: these are unbalanced RCA jacks.
7. GND: a terminal for grounding turntables to eliminate hum.
b) Front Panel (fig. 3)
8. Microphone input: A balanced ¼" jack is mounted on the front face of the
mixer to connect your microphone.
9. Microphone GAIN control: Your microphone has its own gain control so you
can adjust the volume for your microphone.
10. Phones: this ¼" jack is mounted on the front face of the mixer. Use it to
connect your headphones.
6. Specifications
Power supply
Input sensitivity
MIC
PHONO
LINE
Output level (max. output 4V)
MASTER
REC
PHONES
Frequency response
Total harmonic distortion
Stereo separation
Signal-to-noise ratio
MIC
PHONO
LINE
Tone control
Boost at centre frequency
Dimensions
Weight
The information in this manual is subject to change without prior notice.
PROMIX20M
AC 230V / 50Hz
3mV / 1 ohms
3mV / 51Kohms
150mV / 100Kohms
0.775V / 600 ohms
0.4V / 600 ohms
380mA @ 8 ohms
20Hz – 20KHz ±0.5dB
less than 0.02%
more than 45dB
70dB
70dB
80dB
+12dB@100Hz, 10KHz
Hi -26dB @ above 10KHz
Low -26dB @ below 100Hz
347 x 138 x 108mm
2.7kg
3 VELLEMAN