Analog Input Modules (Hpm7000-Im-Ano & Hpm7000-Im-Ani); 11.6.1 Connections, Sr Sensors; 11.6.2 Connection, External Sensor - WEBTEC HPM7000 Manual De Instrucciones

Technical Data
11.6 Analog Input Modules (HPM7000-IM-ANO & HPM7000-IM-ANI)
Designation
Number
Plug
Inputs
Voltage
Power supply
Interface
Housing material
Housing sealing
Type of protection
Ambient temperature
Storage temperature

11.6.1 Connections, SR Sensors

Designation
Number
Plug
Inputs
Voltage
Power supply
Fuse
Accuracy
Input signal range
Scanning rate

11.6.2 Connection, External Sensor

Designation
Number
Plug
Inputs
Voltage
Power supply
Accuracy
Input signal range
Scanning rate
130
Properties
4
3× 5-pin, ODU
1× 5-pin, M12×1
INx-1, INx-2, INx-3, INx-4, INx-5
+24 V
DC
max. 250 mA
Measuring bus based on RS-422
ABS/PC
TPE
IP65
-10 – +50 °C
-20 – +60 °C
Properties
3
5-pin, ODU
INx-1, INx-2, INx-3
+12 V
DC
max. 70 mA
Protection against overvoltage,
short-circuit protected
0.1 % FS (full scale)
-3.4 V – +3.4 V
1 ms = 1,000 measured values/s
Properties
1
5-pin, M12×1
INx-4, INx-5
+24 V
DC
Max. 100 mA
0.1 % FS (full scale)
0/4...20mA / -10...10V
1 ms = 1,000 measured value/s
(FAST MODE at 100 µs)
Description
Galvanically isolated from the
device on HPM7000-IM-ANI.
Thermal fuse
When installed
Description
For Webtec sensors
Analog
Thermal fuse
Active current monitoring for
each channel
= end value of measuring
range
Description
For sensors with current/volt-
age output
Analog
Per network
Thermal fuse
= end value of measuring range