WEBTEC HPM7000 Manual De Instrucciones página 99

Sensors Without Sensor Detection
There are two methods with which to connect sensors without sensor
detection to the device.
Method 1: Direct connection to the analog IN4/5 connection on the analog
input module (HPM7000-IM-ANO & HPM7000-IM-ANI) in accordance
with the figure:
Fig. 49 PIN assignment of sensors without sensor detection
PIN Designation
1 +Ub (+24 VDC)
2 Measuring signal 1 (IN4)
3 GND
4 Measuring signal 2 (IN5)
5 GND
Method 2: Use of an adapter (current/voltage converter). The adapter
is connected between the sensors without sensor detection and the
connection for analog sensors with automatic sensor detection (IN1-
IN3). If a sensors without sensor detection is connected to the device
using this method, further configurations must be completed in the
corresponding menu.
INFORMATION
Further information on connecting sensors without sensor detection
via an adapter and the relevant parameters for configuration is avail-
able in the manual supplied with the respective sensor.
1 2
5
4 3
Operation
99