Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Removal of the heat shield is not required but can be removed to
assist with modification. Cut or bend the area around the rearmost stud to
make clearance for the hitch. Make sure to leave the hole in the heat
shield so that it may be reattached. If removed modify and reattach. (See
figure 5)
Trim
j
5. Fish Wire – Attach items
and
instructions in figure 2. Leave item
raised into position. NOTE: If plastic caps are covering the access
hole remove and return to owner.
©2017 Horizon Global™ Corp. - Printed in Mexico
k
n
to item
and follow the
n
attached until the hitch is
4. Remove Existing Hardware – Remove the existing 10mm bolts (2) each
side from the bulk head.
6. Raise Hitch – Raise hitch into position, be careful not to push the
hardware into the frame. Using the existing 10mm bolts (2) per side
attach the hitch to the bulk head. Then remove item
l
m
j
item
and
to item
.
Sheet 5 of 18
24964NP
n
and attach
07-24-17
Rev. A
Publicidad
