7. Trim Lower Fascia- In the center of the lower fascia cut a 3 inch wide
by a 5 inch long section to give clearance for the receiver tube of the
hitch (see figure 3)
9. Torque Hardware- Tighten all 10mm fasteners to 42 Lb.-Ft. (57
N*M) and all 7/16 fasteners to 40 Lb.-Ft. (68 N*M).
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
©2017 Horizon Global™ Corp. - Printed in Mexico
8. Reinstall Lower Fascia and Plastic Cover- Snap the lower fascia into to place
and reinsert the (2) screws removed in step 2. Then reinstall the plastic
cover with the (4) 10mm nuts and (3) plastic push pins removed in step 1.
10. Raise Exhaust- Raise the exhaust back into position by reattaching the
rubber isolators to the hangers.
Sheet 6 of 18
24964NP
07-24-17
Rev. A