Stop Tracking Function In Harbors - Kongsberg Simrad Marine TV45 Manual

English-16
after:
checking
and the the requested program will appear on the TV. If the display interchanges
between
scanning
be found. Press
Check all cable connections and make sure there is a clear view (no obstacles) to
the satellite and the receiver is correctly adjusted. Then repeat this procedure.
The menu item
tivated (see section 3.1).
Should the antenna lose the signal from the satellite (due to a passing boat,
buildings on shore, bridges, or superstructures on own boat), the display will
interchange between
for the duration of the missing satellite reception.
The tracking mode will automatically restart when the vessel is turned. The
display interchanges between
obstruct the view to the satellite, turn the vessel or the satellite cannot be found!
If you wish to select a specific satellite, refer to section 4.4.

3.1 Stop Tracking function in harbors

If the boat is in a harbor, the tracking function can be deactivated to stop the
tracking (noise-reduction). Proceed as follows:
1. Press repeatedly until the display flashes. This is the main menu.
2. To go to the setup menu, press
(flashing), then press
is correct you are in the Setup menu with the display:
3. Press to select, and press
ing function must be in OFF position to be deactivated. Confirm with
4. The display returns to
shows . Confirm with
quit
You are now back in the main menu and can switch to other satellites or make
adjustments in the setup menu.
When the tracking function is deactivated, the antenna does not track the
satellite, so it is possible that the TV picture sometimes can deteriorate
or drop out. A re-alignment with the satellite is always possible: Press
repeatedly until the display shows
, and then:
complete
and
complete
to go to the main menu and the display will flash
is not shown when the tracking function is deac-
Upd Sat
X (stored position of current satellite) and
Sat
scanning
, Enter password, see section 1.5. If the password
Tracking
. The display returns to:
. The display will now return to
during the search, no suitable satellite could
and
Sat
repeatedly until the display shows
to toggle between ON and OFF. The track-
. Press repeatedly until the display
X (flashing), then press
Sat
Simrad Marine TV
Setup
X. In case superstructures
Tracking
.
Setup
X
Sat
.
,
no Sig
Setup
.
.
.