Kongsberg Simrad Marine TV45 Manual página 18

English-18
5. The display interchanges between
6. Confirm with
7. If you chose 'abandon', the display will briefly show
return to the setup menu i.e.
'confirm', the search mode is activated and the display shows
(flashing). The search mode can be interrupted at any time by pressing ,
which brings you back to the main menu. The display shows
ing).
8. If the tracking system has scanned the whole area without locating a satellite,
the display shows
.
You are back in the main menu with
search mode (see point 1), check if there is a clear view to the satellite, if the
program selected on the receiver is o.k. (possibly change to another program)
and if the respective satellite can be received in this area!
If no satellite is found, repeat the search in another band (see point 3).
Before you restart the search-mode, make sure that no superstructures
obstruct the view to the satellite!
9. The search mode stops after a satellite is found. The display shows
(flashing). Check the quality of the TV picture! In case there
Sat ok?
is no picture or the wrong TV program, proceed with the search mode by
pressing repeatedly until the correct TV program is found. Press
confirm.
10. The display shows
11. A list of the different storage positions is shown. Use the
between
Sat 1
Note! Only free storage positions are shown. Every receiver supporting
the DiSEqC™ function, allocates the satellite positions to one of the
DiSEqC™ positions 1 – 4. Therefore, make sure that all satellites in the
DiSEqC™ menu of the receiver and of the antenna unit are stored under the
same number! This allows the use of the
4.4.2).
Example: Satellite Astra is stored under DiSEqC™ position 2 in the
receiver, meaning that this satellite has to be stored in the antenna unit
under
Sat 2
will allow any order of numbers. Press
, or abandon with .
New Sat
interchanging with
scanning
Save as?
and , confirm with
Sat 4
! Receivers which do not support the DiSEqC™ function
and
New Sat
, continue from point 2. If you chose
flashing. Before restarting the
Setup
just for a brief moment.
.
Auto Sat
.
Simrad Marine TV
.
Search?
and then
cancel
scanning
Setup
. Confirm with
complete
key to toggle
function (see section
(flash-
to