Selection Of Stored Satellites; Manual Selection Of Satellites; Automatic Selection Of Satellites - Kongsberg Simrad Marine TV45 Manual

Simrad Marine TV
If no further satellites are available for deletion, the display shows
.
Tracking
If there are more satellites in the system you wish to delete, press
repeat from point 3! If you want to leave the menu, press
and then press
You are now back in the main menu and can switch to other satellites by press-
ing the key or make adjustments in the setup menu.

4.4 Selection of stored satellites

The satellite tracking system is able to switch between stored satellite posi-
tions (see chapter 3) either by using the control box or the receiver (automatic).

4.4.1 Manual selection of satellites

To select a satellite manually, follow the below procedure:
1. Press repeatedly until the display shows flashing
satellite storage position.
2. Select between the storage positions 1 - 4 by pressing . Confirm with
Only satellites already stored are shown.
The display interchanges between
desired storage position. After the satellite is found, the display will continue
to show X. The satellite tracking system is now in TV mode.

4.4.2 Automatic selection of satellites

To select a satellite automatically, the receiver must support the DiSEqC™
function. Furthermore, it is important that all satellites in the DiSEqC™ menu
of the receiver and of the antenna unit are stored under the same number!
Example: Satellite Astra is stored under DiSEqC™ position 2 in the
receiver, meaning that this satellite has to be stored in the antenna unit
under
Sat 2
1. Press repeatedly until the display flashes
. The display shows
.
(flashing).
Setup
and
scanning
Auto Sat
until
quit
X, where X is the
Sat
X, where X is the
Sat
. Press . From
English-21
and
appears
.