Satellites; Adding New Satellites - Kongsberg Simrad Marine TV45 Manual

Simrad Marine TV

4. Satellites

4.1 Adding new satellites

To search and store new satellites must be done in the harbor in calm waters!
For every satellite at least one program must be preprogrammed in the receiver
to control the satellite position of the antenna unit by means of the TV picture
quality. Make sure the preprogrammed TVstation for the desired satellite is
turned on at the receiver, as the system stops at each receivable satellite. The
satellite can be identified by the quality of the TV picture.
Please proceed as follows:
1. To go to the setup menu, press
(flashing), then press
correct you are in the Setup menu with the display:
2. Press repeatedly until
only appears in the display if free satellite storage positions are
New Sat
available. If all storage positions are occupied, then the less required ones
have to be deleted first. (See section 4.3).
3. The legend
ScnBand?
key to change band between
which the satellite will be searched:
Band 1
Band 2
Band 3
Band 4
Example:
4. Confirm with
. Enter password, see section 1.5. If the password is
New Sat
will be shown for 2 seconds. After that, use the
10700 MHz - 11700 MHz (Polarization Vertical)
10700 MHz - 11700 MHz (Polarization Horizontal)
11700 MHz - 12750 MHz (Polarization Vertical)
11700 MHz - 12750 MHz (Polarization Horizontal)
Astra 1 Band 3
Hotbird Band 3
Astra 2 Band 3
Sirius Band 3
US Band 2
, or abandon with
repeatedly until the display shows
appears. Press
and
Band 1 Band 4
English-17
Setup
.
Tracking
to select.
to select the band in