PULOX PO-200A SOLO Manual De Instrucciones página 23

3) Put the patient's finger into the rubber cushions of the clip (make
sure the finger is in the right position), and then clip the finger.
4) Press the switch button once on front panel.
5) Do not shake the finger and keep the patient at ease during the
process. Meanwhile, human body is not recommended in
movement status.
6) Get the information directly from screen display.
7) The button
off, press the button to turn it on. When the device is on, press the
button shortly to enter the menu. In the state of alarm, press the
button long to pause the alarm for 60s.
B. Change display direction:
The display direction of the screen changes automatically.
C. Pause sound prompt
1. Sound prompt includes over-limit prompt or finger out prompt.
2. In sound prompt "ON" state, when the sound prompt occurs, short
press the button to pause the sound prompt, and it will resume
automatically after about 60s.
3. If you want to turn off the sound prompt permanently, please set it
in menu.
D. Menu operation
a. Main menu
Pulse: When you enter the main menu, „Pulse" is already selected.
Press the button for a few seconds to turn on the pulse sound. Long
press again to switch off the pulse sound. Press the button long to turn
the pulse sound on. Long press again to switch off the pulse sound.
Alarm: Press the button briefly to select „Alarm". Press the button for
a few seconds to turn on the alarm prompt on. Long press again to
switch off the alarm prompt.
Figure 4 Finger Position
has three functions. When the device is
→ Pulse Sound on / off
→ Alarm on / off
→ Sound prompt menu
→ Exit main menu
EN