Deviation Proportion Measurement; Tolerance - Minipa MX-1050 Manual De Instrucciones

E. Deviation Proportion Measurement
Deviation measurement is used to compare the deviation of two elements. The
main display exhibits the nominal value, and the assistant display exhibits the de-
viation in percentage.
Percentage reach: -99,9% ~ 99,9%
Percentage shown in the display: REL%= (Dcur*Dref)/Dref*100%
Dcur: main parameter of measure elements.
Dref: nominal value.
The assistant display exhibits "OL%" and the main display exhibits the main para-
meter of measure elements if Dcur>2Dref or 2Dcur<Dref.
1. Deviation measurement: Press the "FUNC" key to select "AUTO L", "AUTO C",
"AUTO R" or "AUTO DCR" modes. Verify if the test terminals are well connected
on the object to be measure and press the "REL" key to enter in the relative
mode of deviation measurement. The display will exhibit the "
main display exhibits the measure value and the assistant display exhibits the
value of percentage measure deviation in percentage, can also to press the
"REL" key to visualize in the display the nominal value. The "
exhibited and will wink in the display. Press "REL" to leave of the relative mode
and to come back to the original value of the measurement.
F. Tolerance
The tolerance mode is used for elements in which the main parameter is to obtain
a precision in some extent quickly. Press the "FUNC" key to select among "AUTO
L", "AUTO C", "AUTO R" or "AUTO DCR" mode. Verify if the test terminals are well
connected on the object to be measure and press "FREQ" for a while to enter in the
saving mode. The display will exhibit the "SORTING" symbol. The main display will
exhibit "PASS" and the assistant display, the nominal value and a sonorous signal.
The main display exhibits "FALL" and the assistant display exhibits the measure
value of the object.
1. Tolerance adjustment: The tolerance can be of ±0,25%, ±0,5%, ±1%, ±2%, ±5%,
±10%, ±20% or +80% ~ -20%. The standard tolerance is of ±1%. Press the
"SETUP" key to select the tolerance mode desired. The "RANGE" symbol will
be exhibited and will wink in the display. Press "ENTER" to confirm and to enter
in the configuration of the main parameters. The last main parameter will be
indicated in the display for a flashing light. Press the "
value, can also to press the "
the main parameter to move for the right the luminosity position.
" key to increase a value. Press the "
10
" symbol. The
" symbol will be
" key to decrease the
" key of