1. Press " " to turn on the instrument.
2. Press "FUNC" untill the display exhibit "Cp", selecting the capacitance measure
mode.
3. Insert the capacitor in the test input or connect the test lead to perform the mea-
surement.
4. Press the "FREQ" key to select the appropriate test frequency.
5. Press "D/Q/θ" to select the measure assistant parameter.
D. RESISTANCE MEASUREMENTS
WARNING
To avoid damages to the meter or to the devices under test, disconnect cir-
cuit power and discharge all the high-voltage capacitors before measuring
resistance.
1. Press " " to turn on the instrument.
2. Press "FUNC" untill the display exhibit "Rp", selecting the resistance measure
mode.
3. Insert the resistor in the test input or connect the test lead to perform the mea-
surement.
4. Press the "FREQ" key to select the appropriate test frequency.
Note
• In the assistant display will be not exhibited any value.
MX-1050
Figure 14
a
15