Haier QVM7167RNSS Instrucciones De Instalación página 22

Locate the two "knockout" plates, on the rear oven
5
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts
to the oven). Cut all four webs on both rear
knockouts; this will allow the ventilation fan airflow
to exhaust out the rear of the oven.
CAUTION
Be sure to trim the sharp edges
from the openings after removing the knockout
plates.
Oven Rear Panel
6 Place the blower unit back into the opening.
AFTER: Fan
Blade Openings
Facing Back
CAUTION
Do not pull or stretch the
blower unit wiring. Make sure the wires
are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of oven.
7 Replace the blower plate in the same position
as before and replace the screws for the blower
plate and blower motor.Attach the cover on
the blower plate with screw.
Blower
Plate
Screws
22
Installation Instructions
Snip all 4 webs
on each knockout
panel and remove
the metal
knockouts for rear
airflow.
Cover Plate
Blower Plate
Back of Oven
Blower Motor Screws
C5. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
1 Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
Power Cord
Rotate front of microwave oven up against cabinet
2
bottom.
31-7000110 Rev. 1