Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PLACEMENT OF THE MOUNTING PLATE
1
.
REMOVING THE MICROWAVE
A
OVEN FROM THE CARTON
1
Remove the installation instructions, filters, glass
tray, mounting plate, and the small hardware bag.
Do not remove the foam protecting the front of the
oven.
2
Fold back all 4 carton flaps fully against carton sides.
Then carefully roll the oven and carton over onto the
top side. The oven should be resting in the foam.
foam
3
Pull the carton up and off the oven.
4
Set the oven upright. Remove and properly discard
plastic bags and foam packing.
31-7000110 Rev. 1
Installation Instructions
Carton
.
B
FINDING THE WALL STUDS
Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be
3
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
OR
7
Publicidad
Tabla de contenido
