Haier QVM7167RNSS Instrucciones De Instalación página 8

DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET
C
Plate Position – beneath flat bottom
cabinet
Draw a vertical line on the wall at the center of the
30" wide space. Tape the Rear Wall Template onto
the wall matching the centerline and touching the
bottom of the cabinet
Plate Position – beneath recessed bottom
cabinet with front overhang.
Draw a line on the
back wall equal to the
depth of the front
overhang
8
Installation Instructions
30" to Cooktop
Plate Position – beneath framed recessed
cabinet bottom
Draw a vertical line on the wall at the center of the
30" space.
Tape the Rear Wall Template onto the wall matching
the centerline and touching the bottom cabinet
frame.
Your cabinets may have decorative trim that interferes
with the microwave installation. Remove the decorative
trim to install the microwave properly and to make it
level.
THE MICROWAVE MUST BE LEVEL
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back
or side frame, install the mounting plate down the same
distance as the front overhang depth. This will keep the
microwave level.
1
Measure the inside depth of the front overhang.
Draw a horizontal line on the back wall an equal
2
distance below the cabinet bottom as the inside depth
of the front overhang.
For this type of installation with front overhang only,
3
align the Rearwall Template with this horizontal line,
not touching the cabinet bottom as described in Step
D.
30" to Cooktop
31-7000110 Rev. 1