Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 048 06 4.book Seite 19 Donnerstag, 20. Juli 2006 2:18 14
Do not restart the cutting operation if the cutting
wheel is in the workpiece. Let the cutting wheel
reach full speed and then carefully reenter the
cut.
Support the panels or any oversized workpiece to
minimize the risk of wheel pinching or kickback.
Use extra caution during "plunge cuts" in walls or
other blind areas.
Safety instructions, particularly for sanding
work with a sanding disc.
When sanding, do not use an excessively over-
sized sanding disc. Follow the manufacturer's rec-
ommendations when selecting sanding discs.
Special safety instructions for sanding work
with wire brushes.
Be aware that wire bristles are thrown by the
brush even during normal operation. Do not over-
stress the wire bristles by applying excessive load
to the brush.
If the use of a guard is stipulated for sanding with
wire brushes, do not allow the wire bristles to con-
tact the guard.
At a glance.
1 Quick-clamping lever
2 Pressing surface (4x)
3 Auxiliary handle
4 Clamping unit
5 Locking lever (5a) for guard (6c)
6 Standard accessories
Intended use of the power tool.
Operating instructions.
Mounting the auxiliary handle (Figure 3).
Adjustments.
Adjusting the guard (Figure 5).
EN
Publicidad
