Assembly Instructions - Harbor Breeze LP8018LAZ Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. To prevent damage to fan, leave fan in lower foam pad
during hanger system installation. (Fig. 1)
2. The fan comes with black, white and green lead wires.
Remove hairpin clip and clevis pin from downrod assembly (C).
Route lead wires through downrod with rubber sleeve. Install
downrod by pushing downrod with grommet into downrod
support of the motor/fan assembly (A) aligning the holes in
downrod with holes in downrod support. Install the clevis pin
through the holes in the downrod support and holes in the
downrod. Secure clevis pin with hairpin clip. Pull up on the
downrod to assure the clevis pin is properly installed. (Fig. 2)
3. The hanger bracket (B) and canopy (E) come assembled
together in the packaging. Disassemble the canopy (E) from
the hanger bracket (B) by removing two screws. Save screws
installation of canopy later. (Fig. 3)
4. Route wires through motor coupling cover (D) and position it
on top of the motor housing as shown. Then route wires
through the ceiling canopy (E) with open side up. (Fig. 4)
C
A
E
6
Fig. 1
Fig. 2
Line up
holes and
insert pin insert pin
Fig. 3
B
Fig. 4
E
D