Eldom smoof BL1000V Manual De Instrucciones página 13

OPERATING MODES
AUTO:
the appliance will suck out the air and proceed to the mixing cycle. To activate this mode,
press the button (10). The operation is interrupted with the button pressed again (10).
VACUUM: sucking out of the air. To activate this mode, press the button (5). The operation is
interrupted with the button pressed again (5).
JUICE: to activate this mode, set the regulator (4) on the icon
button.
SMOOTHIE: to activate this mode, set the regulator (4) on the icon
Stop button (4a). The operation is interrupted with the button pressed again (4a).
PRE-CLEANING: to activate this mode, set the regulator (4) on the icon
Start/Stop button (4a). The operation is interrupted with the button pressed again (4a).
SPEED CONTROL: turn the regulator (4) in the direction of the icon
To interrupt the operation, reverse the regulator (4) to the left.
In the AUTO mode, sucking out is activated automatically. In the other modes, mixing of products
without air it is possible after pressing the button (6), and selecting the mode.
To switch off the appliance immediately, irrespective of the mode of operation, press the button (6).
NOTE: The lock (8) must never be opened during the operation of the appliance.
DIRECTIONS
- First connect the appliance to the network compliant with the information provided on it. It will
be signalled with a short beep and backlighting of the buttons.
MIXING
- Place food products in the assembled container (3) - do not exceed the maximum position.
Temperature of the ingredients should not be higher than 50°C.
- Place the complete cap (2) on the container and place the unit in the body (Fig. 2). Without the
properly installed container (3) and the properly closed lock (8) the blender will not switch on.
- Press the button (6), and select the mode of operation.
- The maximum time of continuous operation of the appliance is 2 minutes. If this time is exceeded,
immediately switch off the device and wait at least 5 minutes before switching it on again.
- Exceeding the maximum time of work may result in damaging of the device and loss of the
warranty.
- When the operation is complete, dismantle the container (3) (Fig. 3).
- If the VACUUM mode is used, to remove the cap of the container, first pull the handle of the valve
(2a) to reduce negative pressure. Otherwise, opening of the container may be impossible.
NOTE: If the blade is jammed, immediately switch off the blender, disconnect it from the
network and leave to cool down for at least 15 minutes. Eliminate the cause of jamming.
STORAGE
- Place food products in the assembled container (12) - do not exceed the maximum position.
Temperature of the ingredients should not be higher than 50°C.
- Place the complete cap (11) (Fig. 1) on the container and place the unit in the body (Fig. 4).
Without the properly installed container (12) and the properly closed lock (8) the blender will not
switch on.
- Press the button (5) and wait for the appliance to stop running.
- Unlock the appliance and remove the container from the body. After removing the container
from the appliance, negative pressure in the container will last for up to 4 hours.
and press and hold the Start/Stop
and press and hold the Start/
and press and hold the
, and select the rotation speed.
EN 13