Eldom smoof BL1000V Manual De Instrucciones página 14

- To remove the cap of the container, first pull the handle of the valve (11a) to reduce negative
pressure. Otherwise, opening of the container may be impossible.
CLEANING AND MAINTENANCE
SIMPLE CLEANING OF THE MIXING CONTAINER:
- Empty the container and fill it with water, place in the body of the appliance and select the
PRELIMINARY CLEANING mode.
- Pour out the water from the container and wash it.
THOROUGH CLEANING:
- Clean the device right after its use.
- Before cleaning, switch off the device, remove the plug from the socket and wait for the blade to
stop rotating.
- Clean the body of the device with a damp cloth. Do not immerse the body in water and do not
rinse it under running water.
- Do not use abrasive agents, cleaning powders, acetone, alcohol, etc.
- Wash the elements in warm water with addition of washdish with a brush and rinse under running
water.
- Be extremely careful when washing the blade (3a), as it is very sharp.
- The containers (3,12), without the additional elements installed, may be washed in a dishwasher,
placed on the upper shelf. Make sure that they are placed away from the heating element.
The maximum temperature is 50°C.
PROBLEM
The appliance is not running
Appliance is operating, but
not the whole contents of the
jug is mixed
Red control lights are on
Appliance switching off
during the operation
Appliance significantly slowing
down during the operation
ENVIRONMENTAL PROTECTION
- the appliance is made of materials which can be recovered or recycled
- the appliance should be handed over to the appropriate centre of collection and recycling of electrical and electronic
equipment.
WARRANTY
- the appliance is intended for personal use at a household,
- it is not intended for professional purposes,
- in case of misuse, the warranty is rendered null and void.
14 EN
POSSIBLE CAUSE
No power supply
Appliance assembled incorrectly
Product bits too large
Ice blocks too large
The arm (8) locked incorrectly
Operation cycle ended
Operation time exceeded: appliance
overheated
Appliance damaged
Products too hard
SOLUTION
Connect the power supply
dismantle the appliance and assemble it
again
Cut products into smaller pieces
Use smaller ice blocks
Open the lock and close it again
Restart the appliance
Leave the appliance to cool down
Contact the service point
Cut products into smaller pieces and mix
in smaller volumes