Rampage TrailGuard Instrucciones De Instalación página 3

Installation Steps
Make sure the pivot is centered properly in the pass-through hole of the bumper and is straight up. A level may be useful in making sure
5
Insert the Large Bearing Race into the bottom side of the tube on
the Swing Away.
Make sure the Race is fully seated into the machined housing.
6
Place the Large Pivot Washer onto the bearing.
8
Insert the Small Bearing Race into the top of the pivot housing by
tapping evenly all around the edge.
Make sure the race is fully seated into the housing.
10
NOTE: Actual application may vary slightly from illustrations.
the pivot is perpendicular to the ground.
Pack the Large Bearing with Marine-Grade grease.
Insert the Large Bearing into the Race.
7
Insert the Bearing Seal into the housing by tapping evenly all
Make sure the seal is fully seated and flush with the housing edge
9
Place the Swing Away onto the pivot on the bumper.
11
Page 3 of 6
around the seal.