Adjust Particle Sensor - Coway APM-1010DH Manual Del Usuario

ADJUST PARTIcLE SENSOR

When the product is shipped, the pollution sensor is set to normal sensitivity. If the pollution level stays at
the highest level after 2 hours of operating or stays at the lowest level for more than 1 hour when the air
does not appear clean, users can adjust the sensitivity of the sensor.
1
While the air purifier is in operation, press and hold the Airflow
speed and Mode buttons at the same time for 3 seconds or more.
2 The Airflow speed indicator blinks at an interval of approximately
0.5 seconds.
3 Adjust the sensor sensitivity by pressing the Airflow speed button.
The sensitivity of the sensor is represented by the blinking airflow
speed indicator.
Step 1
Sensitive
4 When the Airflow speed and Mode buttons are pressed and held
simultaneously for 2 seconds or more, the system returns to normal
operation, saving the sensitivity setting.
- If no button is pressed for 10 seconds, the current sensitivity is
automatically saved.
Step 2 Step 3
Normal Insensitive
3 seconds
2 seconds
13
14