Mechanical Installation; Mounting Bolt Installation - Alliance Laundry Systems UW35PV Instalación/Mantenimiento

Installation

Mechanical Installation

The optional Premium Wet Clean
Note:
Module does not require permanent
attachment to the floor.

Mounting Bolt Installation

A bolt kit consisting of eight bolts is available
as an option. UW35PV machines use 5/8-11 x
8" bolts. All other UWPV machines use 3/4-10
x 8" bolts. The bolts should be embedded in a
3500 psi minimum reinforced concrete floor
that is a minimum of 12 inches thick. Use the
mounting bolt layouts in Figure 5. (The front
of the washer-extractor is the bottom of each
diagram.)
The threaded end of the bolts should extend
2 inches above the surface of the floor.
See Figure 3 for a typical installation of
individual mounting bolts.
3/4"
19 mm
2"
51 mm
8"
203 mm
Figure 3
20
Frame
Grout
1/2"
13 mm
P034IE3A
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
A bolt-locator fixture or rebar frame is
available as an option. This rigid welded
assembly made of reinforcing rod and
mounting bolts is designed to be embedded
in concrete. See Figure 4.
Machine Base
Mounting
Bolt Threads
Grouting
Reinforcing
Rod
Figure 4
After the concrete has cured, proceed
as follows:
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move the
machine by pushing on the sides. Always
insert a pry bar or other device under the
bottom frame of the machine to move it.
2. Remove the wood skid by unscrewing the
carriage bolts holding the skid to the
bottom frame of the washer-extractor.
3. Place the washer-extractor carefully over
the anchor bolts. Never attempt to lift the
machine by the door handle or by pushing
on the cover panels.
4. Raise and level the washer-extractor
1/2 inch off the floor on three points, using
spacers such as nut fasteners.
P035IE3A
F232084