ROTHOBLAAS COPPO Normas De Seguridad, Instrucciones De Uso E Instalación página 19

USE - REGULATIONS - OPERATION
Homologated as component for Type C system together
with the PATROL anchor line (see specific manual) along EN
795/C:2012, CEN/TS 16415:2013 and UNI 11578/C:2015 stand-
ards for inclined and flat insulated faux roofing tile metal sheet or
similar metal surfaces for 2 persons wearing PPE as per EN 361
and the following fall protection systems as per EN 363:
• Positioning and restraint systems (EN 358)
• Guided type fall arresters including a flexible anchor line (EN
353-2)
• Lanyards (EN 354) with energy absorber (EN 355)
• Retractable type fall arresters (EN 360)
Homologated as component for Type A system together
with the AOS01 anchor eyelet (see specific manual) along EN
795/A:2012, CEN/TS 16415:2013 and UNI 11578/A:2015 stand-
ards for inclined and flat insulated sheet or similar surfaces for 2
persons wearing PPE as per EN 361 and the following fall pro-
tection systems as per EN 363:
• Positioning and restraint systems (EN 358)
• Guided type fall arresters including a flexible anchor line (EN
353-2)
• Lanyards (EN 354) with energy absorber (EN 355)
• Retractable type fall arresters (EN 360)
To ensure safe use, follow the indications provided for each by
the PPE manufacturer.
The device has been tested at 360° (as illustrated below) on all
related substrates.
The manufacturer declares that the product described hereaf-
ter, COPPO, is in conformity with the standards EN 795:2012
type A+C, CEN/TS 16415:2013 Notified body, TÜV Süd Prod-
uct Service GmbH, Ridlerstr.65, 80339 München (test report no.:
713144890-1) and UNI 11578:2015 type A+C.
Rothoblaas COPPO is an anchoring device designed to be in-
stalled on a statically tested substrate (e.g.: bearing structure of
roof) and is used as an anchoring device for personal protective
equipment.
360°
MATERIAL
Rothoblaas COPPO is made of 1.4301 / AISI 304 stainless steel.
INSTALLATION
Indispensable premise is a statically stable substructure. In doubt,
a calculation expert must be called in.
Closely follow the original instructions of the fastener
manufacturer!
Fasten the included M16 stainless steel bolt in the central hole of
the base plate using the 2 washers and the nut so that the free
thread comes out at the top, as shown below. [figure 01]
Stick the 6 cellular rubber strips (included) over the required
holes, so that they are all well covered.
Install by drilling at the centre of the profile a Ø 6,5 mm hole in
the roof sheet, through the holes at the edges (see following
picture) and fasten the element to the sheet with the included
rivets. [figure 02]
Once the device has been fastened, proceed with the drilling of
the remaining holes and then install the rivets.
The device has to be fastened using 24 GESIPA Bulb-Tite Alu/Alu
6,3x20,2 rivets with EPDM washer (included) in total. [figure 03]
SAFETY REGULATIONS, INSTALLATION AND INSTRUCTIONS FOR USE | COPPO | 19