Noise Levels; List Of Spare Parts - Moretti Forni PIZZY MONO 60.60 Manual Instrucciones

5.3.3 REPLACING THE BALL KNOB
After carrying out the operations described in 5.1 above, to
replace the ball knob proceed as follows:
- open the doors of the leavening compartment and remove the plug
- unfasten the ball knob internal fixing nut
- replace the ball knob and fasten the fixing nut (item 2 Plate B)
5.3.4 REPLACING THE THERMOSTAT DIAL AND RING
NUT
After carrying out the operations described in 5.1 above, to
replace the thermostat dial and/or relative ring nut, proceed as
follows from the outside of the compartment:
- remove the snap-on thermostat dial (item 5 Plate B)
- unfasten the fixing nut (item 6 Plate B)
- replace the ring nut and/or the dial
5.3.5 REPLACING THE MAGNETIC DOOR FASTENER
After carrying out the operations described in 5.1 above, to
replace the magnetic door fastener proceed as follows:
- open the doors of the leavening compartment
- remove the seal snap ring
- replace the magnetic door fastener (item 15 Plate B)
5.3.6 REPLACING THE THERMOSTAT
After carrying out the operations described in 5.1 above, to
replace the safety thermostat proceed as follows:
- remove the control panel fixing screws
- disconnect the thermostat faston connectors
- remove the thermostat dial and the ring nut (item 5-6 Plate B),
- remove the thermostat sensor located inside the compartment
(item 7 Plate B)
- replace the thermostat and the relative sensor
- perform the above operations in reverse order to reassemble
4.1.1 REPLACING THE YELLOW INDICATOR LIGHT AND
THE LIGHT SWITCH
After carrying out the operations described in 5.1 above, to
replace the yellow indicator light and the light switch proceed as
follows:
- remove the control panel fixing screws
- disconnect the faston connectors for both the yellow indicator and
the light switch (item 4-14 Plate B)
- replace the yellow indicator light
- replace the light switch
5 perform the above operations in reverse order to reassemble
6

NOISE LEVELS

In compliance with the requirements dated 18 January 1991
concerning machine noise levels, it is hereby stated that this machine
is a piece of technical working equipment that produces no noise,
and that even in extreme cases it does not exceed the noise threshold
of 70 dB (A).
7

LIST OF SPARE PARTS

Index of plates
Plate A General view of pizzy mono duo
Plate B General view of L60.60, L60.60U
Plate C Pizzy mono 60/60 wiring diagram
Plate D Pizzy duo 60/60 wiring diagram
Plate E Compartment wiring diagram
8 INSTRUCTIONS FOR ORDERING SPARE PARTS
Orders for spare parts must contain the following information:
- Appliance type
- Appliance serial number
- Name of part
- Number required
UK/5