EQUIPMENT ASSEMBLY
CAUTION!
Before startiing to assembly the equipment. the following precautions must
be taken:
•Make sure that the packaging is not damaged and that the parts and
componentes of the equipment are not damaged.
•It is recommended that the equipment be unpacked where it will be
assembled.
•The assembly location must be clean.
•The floor must be flat and level to avoid equipment instability.
•The space around the equipment must be free, as described in this manual.
•It is recommended that equipment be mounted away from moisture and out
of sunlight to avoid damage to the electronic parts of the equipment.
•Power Hill comes with an Intensity Led, the assembly for both models is the
same, changing only the Led assembly.
Assembling the equipment requires the following tools:
Allen no. 6
Philips
Allen no. 8
screwdriver
Allen no. 10
SPACE
For the user's safety, we indicate the use
of a minimum access and escape area, as
shown in the picture beside. The access
and escape area can be common among
equipment used.
SCREW TIGHTENING TORQUE
SPECIFICATION TABLE
Diameter
Torque
ICONS
50%
Do not give the
final tightening
of screws
60 cm
2 m
60 cm
100%
Give the final
tightening of
screw
Assembly by two
people is
recommended.