Stel HI-MIG 300K-P Manual Del Usuario página 50

ENGLISH
HI-MIG 300K-P 400V 3F
TECHNICAL DESCRIPTION
COD. 6902100050
with difficulty, decrease the ARC TRIM value.
6) During welding the left-hand display (ref.5 page 9) shows the value of the set wire
speed (expressed in m/min) or of the real current (expressed in Ampere), depending on
whether the reading of the current with the button A (ref.25 page 9) is enabled; on the
right-hand display (ref.7 page 9) you can see the real voltage value (expressed in Volt).
End of welding:
7) Welding will last for the set spot welding time tP; gas will then start to come out for
the time set with the post-gas function.
8) At the end of welding, both displays will keep for a few seconds the real current and
voltage values obtained during welding.
MIG SYNERGIC AND MIG PULSED SYNERGIC WELDING
:
DEFINITIONS
The term MIG synergic welding means a technology that is able to optimise welding
parameters according to the type and speed of the wire, reducing difficulty in
regulations by the user.
The term MIG pulsed synergic welding, like synergic welding, means a technology that
is able to optimise welding parameters according to the type and speed of the wire,
reducing difficulty in regulations by the user; in addition there is a control of the output
current pulses, so as to have a more stable electric arc and to facilitate fusions of
particular materials (such as aluminium), which otherwise would be difficult.
THE PULSED SYNERGIC PROGRAMS ARE INDICATED ON THE FRONT PANEL
p
WITH THE LETTER
ATTENTION: THE SYNERGIES CAN ONLY BY USED IN THE MIG 2 TIMES,
MIG 4 TIMES and MIG SPOT WELDING MODES.
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
50