Stel HI-MIG 300K-P Manual Del Usuario página 51

ENGLISH
Setting and Regulating MIG welding parameters in synergic and pulsed synergic mode
To make welds using the machine's synergic programs, the following settings must
be carried out:
1) Set the desired MIG mode (see previous paragraphs).
2) Inserting synergic mode – Press the SYNERGIC button (ref.26 page 9), this will
switch ON the respective led (ref.27 page 9).
3) Selecting the wire diameter– Press in sequence the SELECT WIRE button
(ref.24 page 9), this will switch on one of the 3 wire diameter leds 0.8 - 1.0 - 1.2
(ref.23 page 9), depending which one you want to weld with.
4) Selecting the program of the material to be welded – Press in sequence the
SELECT PROGRAM button (ref.22 page 9), this will switch on one of the 8 leds
(ref.21 page 9) which refer to the type of material you want to weld. The displays
(ref.5-7 page 9) will show a message indicating the program selected.
ATTENTION – the programs identified with the letter
programs.
5) Regulating the slope down – Regulation active only for the pulsed programs P -
Pressing the SET button (ref.10 page 9) selects the time of the slope down. The
right-hand display (ref.7 page 9) will start to blink, indicating the letters Sd; with the
V/SET encoder (ref.8 page 9) you can regulate the value from 0.01 to 2 seconds.
To view the set value at any time, briefly press the SET button.
6) Adjusting the welding voltage – Regulating the wire speed automatically sets the
optimised voltage for welding; if you want to correct the welding voltage, it is
sufficient to regulate the V/SET encoder (ref.8 page 9), obtaining a variation from –
4V to +4V with respect to the original synergy value.
To view the set adjustment value at any time, turn the V/SET encoder by one
position.
7) Exclusion of synergic mode – Press the SYNERGIC button (ref.26 page 9), this
will switch off the ON led (ref.27 page 9).
DOUBLE PULSE FUNCTION
Regulation active only for the pulsed programs P
To make welds using the machine's double pulse function, the following settings
must be carried out:
1) Set the desired MIG mode and activate a pulsed synergic mode (see previous
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
HI-MIG 300K-P 400V 3F
COD. 6902100050
TECHNICAL DESCRIPTION
P
are pulsed synergic
51