Tabla de contenido
Publicidad
Assembly Instructions
Genuine Parking Distance Warning System, Volkswagen Touran 2016➤
Included:
1 Sensor holder RL
◆
1 Sensor holder RR
◆
2 Sensor holder RLC/RRC
◆
4 Seal (isolating ring)
◆
4 Sensor
◆
1 Control unit
◆
Required special tools, testing and measuring equipment and auxiliary equipment:
Assembly tool for PDC holder -VAS 6614C-
◆
Perceuse manuelle
◆
Voltage tester -V.A.G 1527B-
◆
Threading aid -VAS 6620-
◆
Wiring harness repair kit -VAS 1978-
◆
Vehicle diagnostics tester with ODIS Service
◆
1)
see electronic spare parts catalogue "ETKA"
Installation process:
Notice
The Genuine parking aid should be fitted by an authorised workshop. Incorrect installation may result in damage
◆
to the vehicle or the parking aid.
The Genuine parking aid is not suitable for fitting on vehicles which have subsequently been lowered (sport
◆
suspension, etc.).
The work to be performed on the vehicle, as described in these installation instructions, may vary in some
◆
circumstances as a result of model improvement measures. As such, changes to the wiring colours or even the
fitting locations cannot be discounted. In view of this, please ensure that you always use the appropriate current
circuit diagram or the current vehicle workshop manual.
Only the original German version is definitive. No liability is assumed for translation errors. Subject to technical
◆
modifications.
1.1 Painting the sensors
Notice
Do not clean the sensors with a silicone remover prior to painting but use a mild alcohol (isopropyl) instead.
◆
Additional general information concerning painting:
◆
Self-study programme No. 214/215
Tape off the sensors so that only the visible outside surface of the sensors remains free.
−
Paint the outside surface of the sensors the same colour as the car, applying the paint evenly and not too thickly.
−
−
Repaint as necessary after drying, e.g. clear varnish for twin coat painting.
1.2 Installation of sensors and bumper wiring harness
Installation overview:
Page 2 - Figure 1
1 - Sensor holder rear right (RR), with sensor and seal
Sensor holder 5TA.919.492
◆
Sensor 5Q0.919.275
◆
Seal 5Q0.919.133
◆
2 - Sensor holder rear right/left middle (RRC/RLC), with sensor and seal
Sensor holder 5TA.919.491.A
◆
Sensor 5Q0.919.275
◆
Seal 5Q0.919.133
◆
12
1 Buzzer (tone generator)
◆
1 Bumper wiring harness
◆
1 Retrofit wiring harness
◆
1 Mounting material
◆
1 Installation instructions
◆
Manual cartridge gun -VAS 5155-
◆
Dual component plastic adhesive
◆
Bonding agent for plastics
◆
1)
Cleaning solution
◆
1)
Primer applicator
◆
5TA 054 630
1)
1)
Publicidad
Tabla de contenido
