Installation Instructions; Installation Overview - Volkswagen EBA 054 634 Manual Del Usuario

Installation instructions

Genuine reversing camera system retrofit kit, Golf 2013 ®
Scope of delivery:
1 x Swivelling badge with reversing camera -R189-
◆
and swivel motor
1 x Water drainage hose
◆
1)
not included in the scope of delivery for Golf Variant and Golf Sportsvan
Required special tools, test and measuring equipment and auxiliary equipment:
-VAS 1978- wiring harness repair set
◆
Vehicle diagnostics tester with ODIS service
◆
Installation process:
Note:
The installation of the reversing camera system must be carried out by a competent workshop. Special tools are
◆
needed for the installation as well as detailed, vehicle-specific manuals. Incorrect fitting may lead to damage to the
vehicle or the supplied components.
The work to be performed, as described in these installation instructions, may vary in some circumstances as a
◆
result of model improvement measures. As such, changes to the wiring colours or even the fitting sites cannot be
discounted. In view of this, please ensure that you always use the appropriate current circuit diagram or the current
vehicle workshop manual.
Only the original German version is definitive. No liability is assumed for translation errors. All rights to make
◆
technical changes reserved.

1.1 Installation overview

Page 1 - Figure 1
1 - Information electronics control unit 1 -J794-
Installed in the glove compartment on the right or left
◆
Connection of the video line of the wiring harness supplied
◆
2 - Wiring harness
Scope of delivery
◆
3 - Swivelling badge with reversing camera -R189- and swivel motor
Scope of delivery
◆
4 - Corrugated pipe
Scope of delivery, wiring harness component
◆
Kink protection in the area of the wiring grommet
◆
5 - Relay and fuse holder behind the dash panel
Connection of the voltage supply for the wiring harness supplied
◆
6 - Onboard supply control unit -J519-
Connection of the signal wiring of the wiring harness supplied
◆
1.2 Preparation work on the vehicle
 Remove the top and bottom trims for the tailgate.
 ELSA; Repair Group 70
 Remove the parcel shelf from the vehicle.
 ELSA; Repair Group 70
 Remove the roof profile strip.
 ELSA; Repair Group 70
 Remove the C-pillar trim, right side.
 ELSA; Repair Group 70
Only for 2-door vehicles:
 Remove side trim, right side.
 ELSA; Repair Group 70
Only for 4-door vehicles:
 Remove the wheel arch trim, right side.
 ELSA; Repair Group 70
22
1)
1 x Wiring harness
◆
1 x Installation instructions
◆
Assorted fitting material
◆
Cleaning and pull-in aid -VAS 6620-
◆
Battery charger -VAS 590X-
◆
EBA 054 634