Connecting Scada - MR TAPCON 230 Instructions De Montage

6 Mounting
NOTICE
6.4.5.1 Serial RS485 (D-SUB 9-pole) interface
Maschinenfabrik Reinhausen GmbH 2021

6.4.5 Connecting SCADA

Only available for the TAPCON® 230 Expert and AVT variants.
Damage to the device!
Using the wrong data cable may damage the device.
► Only use data cables which comply with the description below.
Depending on the control system used, you have to connect the device with
one of the following versions.
1. Connect the wires of the shielded cable in pins 7 (Data +), 6 (GND) and 5
(Data-) of the COM-X6 connector.
Figure 24: Connecting wires in pins 7, 6, 5
7820658/01 EN
®
TAPCON 230 39