Elcometer 480 Guia Del Usuario página 11

5 LIMIT STANDARDS - MODEL T (continued)
Limit Standards can be created for individual readings when in live
reading mode or for each batch when in Batching.
To create a manual Limit Standard:
1 Press Menu/Limit Standard/Create Limit Standard/Manual/Create.
2 The 'Setup 20° ' screen will appear. Press 'Yes' to create the limit
standard for the 20° geometry.
é
3 Use the
‡
20° and press 'Ok'.
é
4 Use the
and press 'Ok'.
é
5 Use the
and press 'Ok'.
6 Repeat step 3 - 5 to set the required values for 60°, 85° gloss
‡
and Haze as required.
4
Values do not have to be set for all geometries. If not required, simply
press 'No' to move to the next geometry.
4
A low and / or high limit value can be set. If not required, use the
softkeys to set the value to 'Off'.
7 Press 'Save' to save the values entered or 'Amend' to adjust.
8 The limit standard will be saved in the gauge memory (T) as 'n:
STANDARD n' where 'n; equals 1-40.
To create an automatic Limit Standard:
1 Press Menu/Limit Standard/Create Limit Standard/Automatic/
Create.
2 Place the gauge on an approved surface, press the measure
softkey to start scanning and move the gauge across the surface.
3 Press the measure softkey again to stop scanning.
4 If required, place the gauge on a second sample and press the
measure softkey again. Repeat as required.
5 Press 'Save' to store the average of the scanned 20 , 60, 85
gloss and Haze values as the nominal values for each individual
geometry together with the lowest and highest reading for each
geometry as a 'Limit Standard'. Alternatively, press 'Amend' to
adjust the scanned values before saving or 'Rescan' to disregard
the last scan and scan the surface again.
‡
Model dependent: Dual and Triple Angle models only.
www.elcometer.com
‡
‡
softkeys to set the required nominal gloss value at
ê
softkeys to set the required low limit value at 20°
ê
softkeys to set the required high limit value at 20°
ê
‡
R
‡
‡
‡
é
ê
‡ ‡
en-10