Calibration - Elcometer 480 Guia Del Usuario

5 LIMIT STANDARDS - MODEL T (continued)
If a measurement is outside the set limits, the appropriate limit icon,
the reading value and the reading differential (if enabled) turn red.
If the Limit Standard selected has a high
and low limit set, the high or low limit icon
is displayed next to the appropriate
reading to indicate which limit has been
exceeded.
4
If a measurement falls outside a
defined limit for an angle which is not
displayed on the reading screen, then
the red LED and appropriate limit icon
will turn red.

6 CALIBRATION

6.1 SETTING THE CALIBRATION TILE VALUES
Each gauge is supplied with a certified high gloss calibration tile.
Other certified calibration tile values are available as optional
accessories - see Section 14.1 'Calibration Tiles' on page en-24.
All Elcometer 480 calibration tiles have a pre-programmed RFID tag
which allows automatic identification of the tile's serial number and tile
values for all angles when the tile is attached to the base of any
Model T gauge, allowing automatic calibration.
To enable / disable automatic calibration tile recognition (T):
1 Press Menu/Setup/Calibration/Tile Setup.
é
2 Use the
'Select'.
3 To disable, press 'Select' again to un-check the 'Auto Identify'
radio button.
To calibrate the Elcometer 480 Model B or to calibrate the gauge using
an independent gloss tile, the calibration tile data can be manually
entered into the gauge. The Elcometer 480 Model B does not have
automatic tile recognition therefore, the calibration tile data must be
entered manually.
b
Patent Applied For
www.elcometer.com
softkeys to highlight 'Auto Identify' and press
ê
R
b
en-12