Door Ajar Alarm - Sears Kenmore 106.7200 Manual De Uso Y Cuidado

Door Ajar Alarm
The Door Ajar feature sounds a chime every few seconds when the
refrigerator door has been left open for 5 continuous minutes. The
chime will sound until the door is closed or Door Ajar is turned off.
The light bulbs will turn off if any door is left open for 6 continuous
minutes. Closing all the doors for 1 second will cause the lights to
come back on.
Press the Door Ajar touch pad to turn this feature on or off. The
indicator light will be lit when the Door Ajar feature is on.
Humidity Control (on some models)
The Humidity Control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments or when
you notice moisture on the door hinge seal. The refrigerator uses
more energy when Humidity Control is on.
• Press Humidity Control when the environment is warm and more
humid, or if you notice moisture on the door hinge seal. The
indicator light will be lit when humidity control is ON.
Press Humidity Control again to turn OFF and save energy
when the environment is less humid.
Press If Moisture
Appears
Temp Alarm (on some models)
The Temp Alarm feature provides temperature information in the
event of a power outage.
Power outage: During a power outage, if the temperatures in the
refrigerator and freezer compartments exceed normal operating
temperatures, the highest temperature reached will be displayed.
• Press the Temp Alarm touch pad until the indicator light is lit, to
turn on this feature. Press and hold Temp Alarm for 3 seconds
until the indicator light goes off, to turn off this feature.
Temperature alarm: An alarm will sound repeatedly if the freezer
or refrigerator compartment temperatures exceed normal
operating temperatures for an hour or more.
The temperature displays will alternately show the current
temperatures and the highest temperatures the compartments
reached.
Press the Temp Alarm touch pad once to stop the audible
alarm and alternating temperature displays. The Temp Alarm
light will continue to flash until the refrigerator returns to the set
temperature.
Filter Reset (on some models)
The Filter Reset control allows you to restart the water filter status
tracking feature each time you replace your water filter. See
"Water Filtration System."
• Press and hold the Filter Reset touch pad for 3 seconds, until the
Replace light turns off.
Order Replace
Press & Hold
User Preferences
The control center allows you to set user preferences, if desired.
Temperature Display (F_C)
This preference allows you to change the temperature display.
F - Temperature in degrees Fahrenheit
C - Temperature in degrees Celsius
Alarm (AL)
This preference allows you to turn off the sound of all alarms.
ON - You will hear the alarm sound.
OFF - You will not hear the alarm sound.
Sabbath Mode (SAB)
ON - All control center lights and alarm tones will be disabled.
OFF - All control center lights and alarm tones will be enabled.
NOTE: Press the Door Ajar touch pad for 3 seconds to restore all
lights.
To Accessthe User PreferencesMenu:
1. Press and hold the Door Ajar touch pad for 3 seconds. The
preference name will appear in the Freezer display and the
preference status (F or C) or (ON or OFF) will appear in the
Refrigerator display.
2. Use the Freezer Up Arrow or Down Arrow touch pads to scroll
through the preference names. When the desired preference
name is displayed, press the Refrigerator Up Arrow or Down
Arrow touch pads to change the preference status.
3. Set your preferences by pressing and holding the Door Ajar
touch pad for 3 seconds.
IMPORTANT:
After connecting the refrigerator to a water source or replacing
the water filter, flush the water system. Use a sturdy container
to depress and hold the dispenser lever for 5 seconds, then
release it for 5 seconds. Repeat until water begins to flow.
Once water begins to flow, continue depressing and releasing
the dispenser lever (5 seconds on, 5 seconds off) until a total of
4 gal. (15 L) has been dispensed. This will flush air from the filter
and water dispensing system, and prepare the water filter for
use. Additional flushing may be required in some households.
As air is cleared from the system, water may spurt out of the
dispenser.
• Allow 24 hours for the refrigerator to cool down and chill
water. Dispense enough water every week to maintain a fresh
supply.
14